Analog Devices Inc. SoundMAX(R) Windows(R) 95/98 Driver Driver Version: 4.11.01.0614 INSTALLATION AND REMOVAL INSTRUCTIONS: Installation or Update of Analog Devices SoundMAX Audio Driver NOTE: Remove any previously installed driver using the instructions in the next section. 1. From the task bar, click on Start -> Run. 2. In the Run dialog box, type X:\path\setup, where X:\path is the full path to the source files. 3. Click on the OK button or press the ENTER key. 4. Click on the Next and OK prompts as they appear. 5. Reboot the system to complete the driver installation. NOTE: Some versions of Windows 95 might make it difficult to adjust Microphone gain. Click on the "Advanced" button beneath the Mic volume slider, and then click on the "Mic 20dB Gain" checkbox to adjust the overall gain. Removal of Analog Devices SoundMAX Audio Driver 1. From the task bar, click on Start -> Settings -> Control Panel. 2. Double-click on the Add/Remove programs icon. 3. Double-click on SoundMAXVxD uninstall. 4. Reboot the system to fully uninstall the drivers. UNATTENDED (SILENT) INSTALLATION INSTRUCTIONS: Unattended installations use an InstallShield Silent Response File (setup.iss) to provide user input. Running an Unattended Installation Run SETUP.EXE as described in the installation section above, but with the -s parameter to use the .iss file that is provided with the driver. To use a different setup.iss file, use the -f1 parameter to provide the full path to the file. NOTE: When running an installation in silent mode, no messages are displayed. Instead, a log file named Setup.log captures installation information, including whether the installation was successful. The -f2 parameter can be used to control where the log file is created. Creating a Custom Silent Response File Run Setup.exe as directed above, but with the -r parameter to record the install responses in setup.iss. Use the -f1 parameter to control where the .iss file is created. The line below creates setup.iss in the c:\tmp directory. SETUP.EXE -r -f1c:\tmp\setup.iss HARDWARE AND SOFTWARE DEPENDENCIES: This driver has been designed for and tested with Windows 95 and Windows 98. This driver is intended to be used with Windows 95 OSR2 and Windows 98SE. 1. The system must contain an ICH chip set. 2. The Windows 95 Operating System OSR2, must be installed on the system. 3. Must be installed with DirectX(TM) 5 or greater, but DirectX 6 or greater is recommended. This driver is built for the Microsoft(R) Windows Operating Systems. Copyright 2000, Analog Devices, Inc. All names mentioned herein are a registered trademark or a trademark of Analog Devices or its respective owners. All rights reserved. Document Rev. 1.00