Version 4.03.18 M1Z1; NT4 Install IBM ES1930 Driver English Install Shield 09/23/99 ================================================================ NT 4.0 does not support driver upgrade. To upgrade, uninstall the current driver, reboot, then follow the install directions. Install Directions: 1. From the task bar click on Start -> Run. 2. In the Run dialog box type in X:\path\SETUP.EXE, where X:\path is the full path to the driver files. 3. Choose "Install" 4. At prompt, Reboot Computer Uninstall Directions: 1. From the task bar click on Start -> Run. 2. In the Run dialog box type in X:\path\SETUP.EXE, where X:\path is the full path to the driver files. 3. Choose "Uninstall Drivers" 4. At prompt, Reboot Computer UNATTENDED (SILENT) INSTALLATION INSTRUCTIONS: Unattended installations use an InstallShield Silent Response File (setup.iss) to provide user input. Running an Unattended Installation 1. Run SETUP.EXE as described in the installation section above but with the -s parameter. This will use the .iss file that is provided with the driver. To use a different setup.iss file use the -f1 parameter to provide the full path to the file. NOTE: When running an installation in silent mode, no messages are displayed. Instead, a log file named Setup.log captures installation information, including whether the installation was successful. You can use the -f2 parameter to control where the log file will be created. Creating a custom Silent Response File 1. Run Setup.exe as directed above but with the -r parameter to record the install responses in setup.iss. Use the -f1 parameter to control where the .iss file is created. The line below will create setup.iss in the c:\tmp directory. SETUP.EXE -r -f1c:\tmp\setup.iss