IBM FIRE GL1 Video Adapter FLASH Utility -Ver. 1.19.8           9/18/00
     (Contains video BIOS V1.19)

  Contains support for Oasis 1.1 and 1.2.

  This FLASH can only be used on production level Fire GL1 boards with the
  Oasis Rev. 1.1 video chip.

  To use this FLASH update utility on the IBM Fire GL1 video adapter,
  follow the directions below:

  1.  Place the diskette in drive A and boot from it.  Note, make sure
      the diskette is not write-protected.
        NOTE:  Your system must be set to boot to floppy first.
  2.  Turn your system on.
  3.  Follow the on-screen instructions until the update is complete.
  4.  Reboot the system with either Ctrl+Alt+Del or by powering off, then
      back on.

  NOTE:  Do not attempt to run this FLASH utlity from a DOS prompt under
         either Windows 95 or NT.  It will not work.

  PRESS ANY KEY TO PROCEED WITH THE FLASH UPDATE.