MPC Driver V2.10 February, 2000 REQUIREMENTS ------------ Before installing the MPC driver you must first install the ESCON adapter. The adapter will come with standard Windows NT drivers that must also be installed. Follow the instructions provided in the installation Guide. The following are the minimum required levels of adapter drivers and firmware approved for use with this release of MPC. Microsoft Windows NT: NT Channel Drivers Version 5.5.0 ESCON Adapter Firmware: PBSA v2.3 INSTALLATION (New) ------------ Download and Unzip (Mpc210.zip) into the \TEMP\MPC sub-directory. To install the MPC driver run setup.exe from this directory and it will automatically step you through the installation . After the installation is complete it will be necessary to shutdown and restart Windows NT before using the MPC driver. See the Installation Guide for more details. INSTALLATION (Upgrade) ---------------------- Download and Unzip (Mpc210.zip) into the \TEMP\MPC sub-directory. Upgrading the MPC driver requires de-installation and re-installation. Under the Control Panel open the Add/Remove Programs ICON and remove the MPC Driver, close, and re-boot. After re-boot run the SETUP.EXE program in the \TEMP\MPC sub-directory. NOTE: Remember to record the MPC transmission group configuration settings before removal, otherwise these settings will be lost. See the Installation Guide for more details.