H136551.TXT 2620 LCD COMPONENT FRU PART NUMBERS. TEXT: The following TFT and DSTN LCD components have been released as FRU part numbers for the 2620 systems. ___________________________________________________________ | | | |SEPARATE FRU | |TFT FRU |DESCRIPTION | FRU P/N |COMPONENTS OF | |COMPONENTS | | |THE KITS. | |____________|___________________|__________|______________| |TFT Hinge Kit |P/N11J9524|P/N84G5661 R | | |R&L in kit|P/N84G5662 L | |-------------------+----------+--------------| |2.5 x 6mm adhesive |P/N11J9527|P/N66G5124 | |USE WITH TFT AND | |SCREW KIT. USE| |DSTN | |WITH LOCTITE. | |-------------------+----------+--------------| |TFT LCD Rear Cover |P/N11J9525|P/N84G5654 | |Large Logo (Cover) | in kit |P/N66G5017 | |-------------------+----------+--------------| |TFT Bezel | N/A |P/N84G5655 | |Small Logo (Bezel) | N/A |P/N66G5818 | |-------------------+----------+--------------| |TFT Signal Cable | N/A |P/N84G5659 | |-------------------+----------+--------------| |TFT Inverter Card | N/A |P/N84G5658 | ____________|_____________________________________________| | |DSTN Hinge Kit |P/N11J9522|P/N66G6205 R | | DSTN FRU | |R&L in kit|P/N66G6206 L | | COMPONENTS |-------------------+----------+--------------| |____________|DSTN LCD Rear Cover|P/N11J9523|P/N84G5865 | |Large Logo (Cover) | in kit |P/N66G5017 | |-------------------+----------+--------------| |DSTN Bezel | N/A |P/N66G6200 | |Small Logo (Bezel) | N/A |P/N66G5818 | |-------------------+----------+--------------| |DSTN Signal Cable | N/A |P/N66G6204 | |-------------------+----------+--------------| |DSTN Inverter Card | N/A |P/N84G2395 | |_____________________________________________| Remove Replace Diagrams. ___________________________________________ screw-->O O<-|--screw | ____________________________ | | | | ( ) |<-Small Logo | | Remove Screws and lift | | | | Bezel to disassemble | | | | | | | | | | | | | _ | | | | | ||<--Slider | | | | || | | | | || | | | | || | |____________________________| |_|| | | screw->O O|<--screw |___________________________________________| screw--->|__O____| |__O__|<-------screw LCD Rear Cover ___________________________________________ | O ___+ __ | | Inverter Card Cable------>| _+ | |_| | | | _| || | ____________________| | | || | / _____________________| | <---Inverter | / | |-- || Card LCD | __________| | | || Cable->|+ ___| | || |+_____ | LCD Signal Cable |-- || | | | Position |_ || | | | | || | |__| |__|| | ___|||| | | | __ ||| | |O || |||| O| |__|| |||| _____________________ ____| Ground->|+__((((------------------ |__O__| || |_| |_| <----System Board Cables. Ground------>++ +++ +++ NOTE:(--) on the inverter Asm indecates the cable connector locations for the cables from the LCD panel assembly. NOTE: The TFT power cable has a very low failure rate. If it is found to be defective replace the entire LCD FRU.